ASME A112.19.16 pdf download.Terrazzo Plumbing Fixtures.
ASME A112.19.16 establishes the minimum requirements for terrazzo materials that are used to manufacture plumbing fixtures for general use. It includes material, structural and physical test requirements, and marking and identification of fixtures complying with this Standard.
The provisions of this Standard are not intended to prevent the use of any alternate design that meets or exceeds the intent of this Standard.
1.2 Units of Measurement
Values are stated in U.S. Customary units and in the International System of Units (SI). The US. Customary units shall be considered as the standard.
1.3 References
The following documents form a part of this Standard to the extent specified herein. Unless otherwise specified, the latest edition shall apply
ASME A112.18.2/CSA Bl25.2, Plumbing Fixture Waste Fittings
Publishers: The American Society of Mechanical
Engineers (ASME), Three Park Avenue, New York,
NY 10016-5990; Order Department: 22 Law Drive.
P.O. Box 2300, Fairfield, NJ 07007-2300, and Canadian
Standards Association (CSA), 5060 Spectrum Way,
Mississauga, Ontario, Canada [.4W 5N6
ASTM C 150, Standard Specifications for Portland Cement
ASTM F 409, Thermoplastic Accessible and Replaceable Plastic lube and Tubular Fittings
ASTM F 462, Slip Resisting Bathing Facilities
Publisher: American Society of Testing and Materials (ASTM International), 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959
CSA 845 Series, Plumbing Fixtures cSA 8125.3, Plumbing Fittings
Publisher: Canadian Standards Association (CSA), 5060 Spectrum Way, Mississauga, Ontario, Canada 4W 5N6
IAPMO/ANSI Z124.1.2, Plastic Bathtub and Shower Units
IAPMO/ANSI Z124.3, Plastic Lavatories
3.2 SUp Resistance
3.2.1 Test Method. The surfaces of the bathing area of the shower receptor shall be slip resistant and shall comply with ASTM F 462.
3.2.2 Performance RequIrements. The test samples that do not comply with the performance requirements as set forth in the ASTM standard shall be cause for rejection of the product.
3.3 Surface
3.3.1 Test Method. Terrazzo bathtubs, shower receptors, wash fountains, and lavatories/lavatory systems shall meet the requirements of IAL’MO/ANSI Z124.1.2, IAPMO/ANSI Z124.3, IAPMO/ANSI Z124.6, or CSA 845.5 for stain resistance, chemical resistance, wear and cleanabi1it and thermal shock resistance.
3.3.2 Performance Requirements. The test samples that do not comply with the performance requirements as set forth in the applicable ANSI or CSA standard shall be cause for rejection of the product.
4 MARKING AND IDENTIFICATION
Each fixture shall be permanently marked with the manufacturer’s name or trademark. Acceptable means of applying permanent marking shall include fired-on, etching, stamping with permanent (nonwater-soluble) ink, and cast-in markings. Such marking shall be located when it can be seen after installation. Adhesive labels that comply with UL 969 shall also be considered permanent when installed on areas of the fixture that are not normally submerged in water. The exposure conditions for labels contained in para. 7.1 of UL 969 shall apply along with the additional exposure to the detergent test specified in Table 7.4 of UL 969.
Each fixture shall be supplied with srrittcn care and maintenance instruct ions, including sealing recommendations and installation instructions.
ASME A112.19.16 pdf download
